Bubble plate kit 3" TC PolyPhoenix PPSU

What do Bubbler Plates do?

Bubble plates are used to create more reflux in the column. Think of it like modular distillation chambers that allow alcohol vapour to pass up the column, as well as a "downcomer" that lets excess liquid on the plate fall back to the plate below. Each time refining and changing phase over and over until it reaches a condenser. This helps to regulate the rate that good spirit is collected and can help to produce a more consistent, high-quality spirit.

This rising and falling action helps to separate the different types of alcohol in the still, with lighter alcohols gradually moving upwards where they can be removed so that they don't form part of the final product. The heavier alcohols, on the other hand, remain lower in the column and are eventually removed once the unwanted alcohols that form the foreshots, and heads are removed.

Why would I use a Bubbler Plate?

They allow for greater control over the distillation process. The distiller can adjust the height of the plates to control the reflux ratio, this is the amount of vapour that is condensed and returned to the column.

Do Bubbler Plates have to be Copper? (Short Answer...Yes)

Having a high level of copper contact helps neutralise and remove flavour and aroma compounds that aren't desirable in the finished product, and by forcing the alcohol vapour to pass through the bubble plates multiple times this effect is greatly enhanced.

General Rules of Thumb:

• 3 Plates is for absolute maximum flavour transfer of your Whiskey, Rum or Brandy (WRB)
• 4 Plates is a perfect middle ground for versatility of higher strength with a lot of flavour passthrough
• 5 Plates is for even greater strength distillate with still quite a bit of flavour pass over
• 7 Plates will get you the highest purity, but the least amount of flavour carry over

This Kit Includes:

• 1 x KL36979 PolyPhoenix - Straight Extension - PPSU 3 Inch TC
• 2 x KL39567 Quick Swivel Connector 1/2' x Stainless Steel End Cap (18mm)
• 1 x KL37914 PolyPhoenix - Bubble Capper Plate Assembly - 3 Inch TC
• 1 x KL25799 3 Inch TC Clamp - 3 Segments